How to Find Satellite? Please use MR-077 Satellite locator and Satellite finder SF-95 to find signal which method refer to our installation book. Assembly & Installation The assembly of dish antenna is mostly done by snap fitting, some thumb bolts are used to secure the assembly. To make sure to tighten the thumb bolts to the flat faced end/boss of the ball joint, which method refer to installation book. MR-037 has the following Multi-Mounting Applications : 1. Clamp of Balcony Rail  Clamp on the balcony rail as described in the clamping of the vertical pole. If the Square rod will not be used, insert the end of the ball joint of the Dish assembly into the square recess of the C clamp. Secure the Dish assembly by tightening the thumb bolt. 　 　 2. Clamp on Table Clamp on the table as described in the clamping of the vertical pole.Insert the end of the ball joint of the Dish assembly into the square recess of the C clamp.Secure the Dish assembly by tightening the thumb bolt. 3. Use of Suction Stand Place the Suction stand on clean smooth surface (i.e. the car body, glass or well polished metal surface). Press the Suction stand down and turn the triangle knob clockwise each by each to keep all the three suckers be sucked on the surface. Place the Dish assembly on the suction stand by aligning the end of the ball joint to the boss of the Suction stand. Secure the dish assembly by tightening the thumb bolt. 4. Use of the Wall Mount Position the Wall mounting bracket on the southward wall, secure the Wall mounting bracket by wall bolts which are included in the polybag. Position the Square rod to fit into the square recess of the Wall mounting bracket, secure the Square rod by tightening the wing nuts. Place the Dish/Arm/LNB Clamp assembly on the Square rod by fitting the ball joint end into the hole of the end tip of the Square rod. Secure the Dish assembly by tightening the thumb bolt. 5. Clamp on Vertical Pole Position the C clamp to clamp on the pole.Fit the Square rod into the square recess of the C clamp and push to the end. Tighten the thumb bolt to secure the Square rod.Place the dish assembly on the end tip of the Square rod. Aligning the end of the ball joint to the hole of the Square rod, secure the Dish assembly by tightening the thumb bolt. 6.The super secure three cup suction stand mount can be used on R.V.s, over the road trucks, passenger cars or any glass surface. 7. Using the optional marine mount with screws the flyer can be firmly attacked to a boat or yacht. The unit will operate perfectly when craft is moored.