mrx-1000-title.jpg (9380 bytes)

　 　
mrx-1000-key.jpg (1995 bytes) t5.gif (2865 bytes)
fta-setup.gif (3299 bytes) tech-key.gif (2903 bytes)

  • MRX-1000 is used for all linear FTA satellites.
    FTA linear satellites includes the following: IntelSat Americas 5 (Telestar5), IntelSat Americas 7, IntelSat Americas 6, IntelSat Americas 12, AMC 4, Galaxy 11, Galaxy 3C, Galaxy 4R, Galaxy 10R and SatMex5.

  • For these FTA satellites above, using one dish, one MRX-1000 or MRX-900 FTA receiver as well as a set of our H2H Motorized Mount, you can then choose among all the different channels from various satellites. All you have to do is simply sit in front of the TV and enter the info for the satellite that you want to watch, then our H2H Motorized Mount will move the dish to the correct angles to allow viewing of a specific FTA satellite.

  • MRX-1000 also come with games pre-installed in the receiver, including Tetris, Colorball, Gobang Game, Sokoban, Mine Game, and Flipmix.
    　

  • ATTENTION: ANY MICROYAL RECEIVER THAT HAS BEEN INSTALLED ANY OTHER SOFTWARE THAT IS NOT MICROYAL'S ORIGINAL SOFTWARE DOES NOT QUALIFY  FOR MICROYAL WARRANTY. IF MICROYAL RECEIVERS BECAME DEFECTIVE DUE TO INSTALLATION OF ANY OTHER SOFTWARE THAT'S NOT MICROYAL'S ORIGINAL SOFTWARE, MICROYAL WILL NOT PROVIDE ANY AFTER-SERVICE, EITHER REPAIR OR REPLACE, FOR THOSE RECEIVERS. IT IS NOT MICROYAL'S RESPONSIBILITY TO PROVIDE AFTER-SERVICE FOR THOSE RECEIVERS THAT HAVE BEEN IMPROPERLY PROGRAMMED BY USERS OR DEALERS.

SPECIFICATION

Tuner & Channel A/V Data In/Out
Connector 2 x F-Type, 3/8-32UNEF-2A CVB S Video Output RCA x 1
1 IF Loop through Yes Output Impedance 75*, RCA*1
Frequency Range 950 ~ 2150 MHz Output Level 1.0V ± 20mVp-p
Input Impedance 75* unbalanced Freq. Feature ± 0.5dB (4.8MHz)
Digital Signal Input Level -25 ~ -65dBm Differential Gain £ 5%
LNB Supply 13.0V / 18.0V (max.400mA), Short Circular Protection Differential Phase £ 5°
C/L Delay £ 30nS
22KHz Tone AUDIO R/L RCAx1 (L&R)
Frequency 22 ± 4KHz Output Imedance 680*, RCA*1
Amplitude 0.6 ± 0.2V Output Level ±6dB
DiSEqC Control Version 1.0/1.2 Compatible Freq. Feature ±0.5dB (20Hz ~ 18Hz)
Demodulation QPSK Audio S/N Ratio ³ 70dB
Input Symbol Rate 2 ~ 45 MSPS Difference of Left & Right Track Level £ 0.5dB (20Hz ~ 18Hz)
FEC Decoder Convolutional Code Rate 1/2, 2/3, 3/4,
5/6 and 7/8 with Constraint Length K=7
MPEG Transport Stream A/V Decoding RF Modulator System NTSC
Transport Stream MPEG-2 ISO/IEC 13818 Channel Ch. 3~4 (NTSC)
Profile Level MPEG-2 MP@ML Return Loss 6dB max.
Input Rate Max. 60Mbit/s Audio Mono
Aspect Ratio 4:3, 16:9 Connector 75*, IEC/F-Type
Video Resolution 720 x 576(PAL); 720 x 480(NTSC) Bypass Bandwidth 45 ~ 862MHz
Output System PAL/NTSC/AUTO RS-232 Data Port 9 pin D-sub Type, Baud rate 9600-115200Kbps
Audio Decoding MPEG layer I and II, Musicam
Audio Mode Stereo channel, Dual Mono, Joint Stereo channel, Mono Environment
Operating Temperature + 5°C ~ + 50°C
Sampling Rate 32, 44.1 and 48 KHz Storage Temperature - 40°C ~ + 65°C
Memory Power Supply
CPU SGS-Thomson STi5518 Main Input Voltage 90 ~ 250V AC @ 50Hz/60Hz
SDRAM Memory 4Mbyte Type SMPS
Flash Memory 2Mbyte Nominal Power Consumption Max. 25W
Physical Specification
Size (WxHxD) 370mm x 250mm x 60mm
Weight (net) about 2.0Kg

Note: For software transfer from PC--Receiver or from Receiver--Receiver, use our RS-232 Cross Pin Cable.

RS-232

Used for PC--Receiver & Receiver--Receiver Software Transfer. This is the cable wire that you use along with all MRX-receivers. This is a null modem cable.