NOTE: While cascading SW-44 with SW-44A, please make sure that
you cap all the empty ports with our 75Ω terminator to prevent signal loss.

The following is the cascading diagram of SW-44A multi switch with DP-44 launch amplifier.

*** For all Microyal switches (esp. SW-21, SW-21X, SW-44,SW-44A and SW-64),
please make sure the connector and the RG6 cable are installed as follows.
The central copper wire of the cable must extend pass the connector by 2m/m
or else there might be signal loss, resulting in "no signal" from the receiver.